fully updated

Marlin/Configuration_adv.h

@@ -910,7 +910,7 @@
 
   // Safety: The probe needs time to recognize the command.
   //         Minimum command delay (ms). Enable and increase if needed.
-  //#define BLTOUCH_DELAY 500
+  #define BLTOUCH_DELAY 500
 
   /**
    * Settings for BLTOUCH Classic 1.2, 1.3 or BLTouch Smart 1.0, 2.0, 2.2, 3.0, 3.1, and most clones:
@@ -936,7 +936,7 @@
    * differs, a mode set EEPROM write will be completed at initialization.
    * Use the option below to force an EEPROM write to a V3.1 probe regardless.
    */
-  //#define BLTOUCH_SET_5V_MODE
+  #define BLTOUCH_SET_5V_MODE
 
   // Safety: Enable voltage mode settings in the LCD menu.
   //#define BLTOUCH_LCD_VOLTAGE_MENU
@@ -1445,7 +1445,7 @@
   #endif
 
   // Scroll a longer status message into view
-  //#define STATUS_MESSAGE_SCROLLING
+  #define STATUS_MESSAGE_SCROLLING
 
   // Apply a timeout to low-priority status messages
   //#define STATUS_MESSAGE_TIMEOUT_SEC 30 // (seconds)
@@ -2064,7 +2064,7 @@
  *
  * Warning: Does not respect endstops!
  */
-//#define BABYSTEPPING
+#define BABYSTEPPING
 #if ENABLED(BABYSTEPPING)
   //#define INTEGRATED_BABYSTEPPING         // EXPERIMENTAL integration of babystepping into the Stepper ISR
   //#define BABYSTEP_WITHOUT_HOMING
@@ -2393,16 +2393,16 @@
 #if BOTH(SDSUPPORT, DIRECT_STEPPING)
   #define BLOCK_BUFFER_SIZE  8
 #elif ENABLED(SDSUPPORT)
-  #define BLOCK_BUFFER_SIZE 16
+  #define BLOCK_BUFFER_SIZE 32
 #else
-  #define BLOCK_BUFFER_SIZE 16
+  #define BLOCK_BUFFER_SIZE 32
 #endif
 
 // @section serial
 
 // The ASCII buffer for serial input
 #define MAX_CMD_SIZE 96
-#define BUFSIZE 4
+#define BUFSIZE 64
 
 // Transmission to Host Buffer Size
 // To save 386 bytes of flash (and TX_BUFFER_SIZE+3 bytes of RAM) set to 0.
@@ -2648,7 +2648,7 @@
  *
  * Enable PARK_HEAD_ON_PAUSE to add the G-code M125 Pause and Park.
  */
-//#define ADVANCED_PAUSE_FEATURE
+#define ADVANCED_PAUSE_FEATURE
 #if ENABLED(ADVANCED_PAUSE_FEATURE)
   #define PAUSE_PARK_RETRACT_FEEDRATE         60  // (mm/s) Initial retract feedrate.
   #define PAUSE_PARK_RETRACT_LENGTH            2  // (mm) Initial retract.